RK3288 Android11 RTL8723DS WiFi 和蓝牙Bluetooth 适配

04-11 1257阅读

一、RTL8723DS WiFi 适配 — 篇章

1、原理图分析（WiFi部分）

补充:RTL8723DS时钟输入源讲解

RTL8723DS模组的第24号引脚是模组的时钟输入源，需要给此提供1.8V~3.3V，32KHz的输入源。由原理图可知，提供时钟输入源的是RK808 CLK32KOUT1引脚提供的外部32KHz时钟。因此需要添加：

clocks =;
clock-name = "ext_clock";

PATCH文件和规格书和参考文档👈 — 提取码：baeg

2、根据原理图修改设备树和编辑驱动文件

由原理图可以看出，板子上使用的RTL8723DS模块WIFI部分的接口是SDIO接口的，因此在设备树上修改对应的GPIO即可。

Ⅰ、首先打开对RTL8723DS模块的供电，也就是WL_ON引脚->GPIO8_A4，先需要使用pinctrl将其复用成GPIO功能，然后将其WL_ON引脚拉低电平，让其P-MOS管导通，处理方法如下图所示：

我这在HD_gpio_control.c这个GPIO驱动程序上初始化GPIO8_A4，默认拉低电平，如下图所示，这里随意写个驱动即可。

Ⅱ、修改sdio0设备树节点，如下图所示：

将RTL8723DS驱动添加到内核吗，如下图所示：

Ⅳ、修改make menuconfig，如下图所示：

3、实验验证

通过以上配置，基本驱动移植就配置好了，如下图所示：

4、RTL8723DS WIFI驱动参考文档和博客网站

博客参网站👈

路径：a\RKDocs\android\wifi\Rockchip_Introduction_REALTEK_WIFI_Driver_Porting_CN&EN.pdf和a\RKDocs\android\wifi\Rockchip_Introduction_WIFI_Configuration_CN&EN.pdf

二、RTL8723DS 蓝牙Bluetooth 适配 — 篇章

1、原理图分析（蓝牙Bluetooth部分）

上图黄色框框就是本次蓝牙功能适配需要关注的引脚接口。

2、根据原理图修改设备树

3、修改蓝牙相关的配置

diff --git a/device/rockchip/common/init.connectivity.rc b/device/rockchip/common/init.connectivity.rc
index 40fa8d31b2..66c4abf930 100755
--- a/device/rockchip/common/init.connectivity.rc
+++ b/device/rockchip/common/init.connectivity.rc
@@ -17,16 +17,16 @@ on zygote-start
     chown bluetooth net_bt ro.bt.bdaddr_path
     setprop ro.bt.bdaddr_path "/data/misc/bluetooth/bdaddr"
 
-    #chmod 0660 /dev/ttyS0
+    chmod 0660 /dev/ttyS0
     chmod 0660 /dev/ttyS1
-    #chmod 0660 /dev/ttyS8
+    chmod 0660 /dev/ttyS4
     chmod 0660 /dev/vflash
     chmod 0664 /dev/vendor_storage
     chown bluetooth net_bt /dev/vflash
     chown bluetooth net_bt /dev/vendor_storage
     #chown bluetooth net_bt /dev/ttyS0
-    chown bluetooth net_bt /dev/ttyS1
-    #chown bluetooth net_bt /dev/ttyS8
+    #chown bluetooth net_bt /dev/ttyS1
+    chown bluetooth net_bt /dev/ttyS4
     chown bluetooth net_bt /sys/class/rfkill/rfkill0/type
     chown bluetooth net_bt /sys/class/rfkill/rfkill0/state
     chmod 0664 /sys/class/rfkill/rfkill0/state
diff --git a/device/rockchip/common/ueventd.rockchip.rc b/device/rockchip/common/ueventd.rockchip.rc
index b69c909155..92fac57a91 100755
--- a/device/rockchip/common/ueventd.rockchip.rc
+++ b/device/rockchip/common/ueventd.rockchip.rc
@@ -65,18 +65,18 @@
 /dev/gps                  0660   gps        gps
 
 # for BT
-/dev/vflash               0660   bluetooth  net_bt
 /dev/ttyS0                0777   system        system
-/dev/ttyS1                0660   bluetooth  net_bt
+/dev/ttyS1                0777   system     system
 /dev/ttyS2                0777   system        system
 /dev/ttyS3                0777   system        system
-/dev/ttyS4                0777   system        system
 /dev/ttyS5                0777   system        system
 /dev/ttyS7                0777   system        system
 /dev/ttyS8                0777   system        system
 /dev/ttyS9                0777   system        system
 
-/dev/rtk_btusb            0660   bluetooth  net_bt
+/dev/vflash               0660   bluetooth  net_bt_stack
+/dev/ttyS4                0660   bluetooth  net_bt_stack
+/dev/rtk_btusb            0660   bluetooth  net_bt_stack
 
 #for hid audio
 /dev/hidraw0              0660   audio  audio
diff --git a/device/rockchip/rk3288/bluetooth/rtkbt.conf b/device/rockchip/rk3288/bluetooth/rtkbt.conf
index 2bc297212b..42951cb793 100644
--- a/device/rockchip/rk3288/bluetooth/rtkbt.conf
+++ b/device/rockchip/rk3288/bluetooth/rtkbt.conf
@@ -9,7 +9,7 @@ DevClassMinorClass=0x1C
 
 #Indicate USB or UART driver bluetooth
 #BtDeviceNode=/dev/rtk_btusb
-BtDeviceNode=/dev/ttyS0
+BtDeviceNode=/dev/ttyS4
 
 # Enable BtSnoop logging function
 # valid value : true, false
diff --git a/device/rockchip/rk3288/rk3288_Android11/bt_vendor.conf b/device/rockchip/rk3288/rk3288_Android11/bt_vendor.conf
index 3714843d5b..a133cad89f 100755
--- a/device/rockchip/rk3288/rk3288_Android11/bt_vendor.conf
+++ b/device/rockchip/rk3288/rk3288_Android11/bt_vendor.conf
@@ -1,5 +1,5 @@
 # UART device port where Bluetooth controller is attached
-UartPort = /dev/ttyS0
+UartPort = /dev/ttyS4
 
 # Firmware patch file location
 FwPatchFilePath = /vendor/etc/firmware/
diff --git a/hardware/realtek/rtkbt/code/libbt-vendor/include/bt_vendor_rtk.h b/hardware/realtek/rtkbt/code/libbt-vendor/include/bt_vendor_rtk.h
index a11546837e..f5a6080ffe 100755
--- a/hardware/realtek/rtkbt/code/libbt-vendor/include/bt_vendor_rtk.h
+++ b/hardware/realtek/rtkbt/code/libbt-vendor/include/bt_vendor_rtk.h
@@ -87,7 +87,7 @@
 
 /* Device port name where Bluetooth controller attached */
 #ifndef BLUETOOTH_UART_DEVICE_PORT
-#define BLUETOOTH_UART_DEVICE_PORT      "/dev/ttyS1"    /* maguro */
+#define BLUETOOTH_UART_DEVICE_PORT      "/dev/ttyS4"    /* maguro */
 #endif
 
 /* Location of firmware patch files */
diff --git a/hardware/realtek/rtkbt/vendor/etc/bluetooth/rtkbt.conf b/hardware/realtek/rtkbt/vendor/etc/bluetooth/rtkbt.conf
index a1e9b39361..c137c0ebd5 100755
--- a/hardware/realtek/rtkbt/vendor/etc/bluetooth/rtkbt.conf
+++ b/hardware/realtek/rtkbt/vendor/etc/bluetooth/rtkbt.conf
@@ -9,7 +9,11 @@ DevClassMinorClass=0x1C
 
 #Indicate USB or UART driver bluetooth
 #BtDeviceNode=/dev/rtkbt_dev
-BtDeviceNode=?/dev/ttyS1:H5
+BtDeviceNode=?/dev/ttyS4:H5
+
+# Enable BtSnoop logging function
+# valid value : true, false
+RtkBtsnoopDump=true
 
 # BtSnoop log output file
 BtSnoopFileName=/data/misc/bluedroid/btsnoop_hci.cfa
diff --git a/hardware/realtek/rtkbt/vendor/etc/bluetooth/rtkbt_S0.conf b/hardware/realtek/rtkbt/vendor/etc/bluetooth/rtkbt_S0.conf
index 87a8241f17..89cd47356a 100755
--- a/hardware/realtek/rtkbt/vendor/etc/bluetooth/rtkbt_S0.conf
+++ b/hardware/realtek/rtkbt/vendor/etc/bluetooth/rtkbt_S0.conf
@@ -9,7 +9,7 @@ DevClassMinorClass=0x1C
 
 #Indicate USB or UART driver bluetooth
 #BtDeviceNode=/dev/rtk_btusb
-BtDeviceNode=?/dev/ttyS0:H5
+BtDeviceNode=?/dev/ttyS4:H5
 
 # Enable BtSnoop logging function
 # valid value : true, false